REV 45mm Flat Plate is a 45mm wide, bendable metal featuring the Extended Motion Pattern. This product is a piece that is 88mm long. The Extended Motion Pattern supports M3 hardware for attaching brackets, extrusion, and channel.

This metal Flat Servo bracket is used with the REV 15mm Extrusion System. Version 2 brackets offer many improvements over our previous metal brackets, including holes on an 8mm grid that is compatible with many other building systems.

This metal 60 degree bracket is used with the REV 15mm Extrusion System. Version 2 brackets offer many improvements over our previous metal brackets, including holes on an 8mm grid that is compatible with many other building systems.

This metal 45 degree bracket is used with the REV 15mm Extrusion System. Version 2 brackets offer many improvements over our previous metal brackets, including holes on an 8mm grid that is compatible with many other building systems.

The servo mount bracket can be used with the REV 15mm Extrusion System and fits the REV Robotics Smart Robot Servo as well as most other similar form factor servos.

This bracket can be used with the REV 15mm Extrusion System with a REV Robotics Bearing seated in the 9mm center hole as a shaft support bracket. This bracket has alignment ribs on one side which are designed to seat the bracket into the extrusion channel increasing joint alignment, strength, and rigidity.

This 90 degree plastic bracket is used with the REV 15mm Extrusion System. Each bracket includes a set of alignment ribs designed to seat the bracket into the extrusion channel increasing joint alignment, strength, and rigidity.

For smaller applications the REV Building System also comes in a 15mm x 15mm square extrusion. The slots are designed to fit standard M3 hardware rather than expensive t-nuts.

REV Building System also comes in a 15mm x 30mm square extrusion. The slots are designed to fit standard M3 hardware rather than expensive t-nuts. Use the 15mm x 30mm extrusion when more strength is needed for an application.

This bracket allows you to easily mount standard size servos to the 15mm REV Extrusion. It has a 90 degree bend on the mounting face.